NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

Chapter 12 265
Gateway Half Network Interface Configuration Screens
Security String(s) Configuration
Security String(s) Configuration
The Security String(s) Configuration screen (#110) supplies the security
string required by the dial ID protocol for the node you are configuring.
Note that the security string is not required if dial ID protocol is not
enabled. This screen, shown in Figure 12-7, is displayed if you press the
[Go to SECURITY] function key at the preceding Dial ID Protocol
Configuration screen (Figure 12-6). It is also displayed when you type:
@NETXPORT.NI. NIname .PROTOCOL.DIAL.SECURITY
in the command window of any screen and press the
[Enter] key, where
NIname is the configured gateway half NI.
Figure 12-7 Security String(s) Configuration Screen
Press the
[Save Data] function key to transfer the data displayed on the
screen to the configuration file you are creating or updating. Verify that
the data record has been created by checking that the Data flag is set
to Y.