NS3000/iX NMMGR Screens Reference Manual - Edition 8 (36922-90038)

38 Chapter3
Link Configuration Screens
LAN Link Configuration
For some HP systems, you must specify a channel
number (ccc) and subchannel number (sss) in the
form ccc.sss while others require a bus converter
number followed by a slash (/) and then a channel
number (ccc) and subchannel number (sss) in the
form b/ccc.sss.
If you are unsure of the slot location or of the physical
path number to configure for your system, see your
system documentation or consultyour Hewlett-Packard
service representative.
Use factory-
configured local
station address?
(HP modifiable.) The LANIC board is supplied with a
48-bit station address. These are guaranteed to be
unique. Do not change the factory configured local node
address except on the specific instructions of your
Hewlett-Packard representative.
Default value: Y
Local station
address (modifiable.) This field is to be used only with specific
instructionsfrom your Hewlett-Packardrepresentative.
It allows you to enter a station address to replace the
factory configured address. The format must be
compatible with HP software requirements. Your
Hewlett-Packard representative will supply
instructions in the unlikely event that you need to
enter an address to replace the default.