Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 7 139
Managing Networks with DTCCNTRL
Dynamic Configuration
Host-based X.25 configuration changes:
• change PAD access
• change level 1, 2, or 3 configuration
Use DTCCNTRL to:
1. Stop X.25/PADSUP
2. Start X.25/PADSUP
(seeConfiguring Systemsfor Terminals,
Printers, and Other Serial Devices for
more information)
Add/configure new DTC Reboot or reset DTC
or
Perform automatic configuration
Add/configure a TIO carD
Change DTC IP address
Change AFCP/management timers
Change SNMP MIB data
Change SNMP trap destination
1. Logoff any sessions that were logged on
through the changed DTC
2. Reboot DTC
You may also use TermDSM to reset the
DTC (see Troubleshooting Terminal,
Printer, and Serial Device Connections
or more information)
Change from host-based TIO to host-based X.25
Change DTC LAN address
Change DTC name
Change DTC node name
Change from PC-based to host-based or vice
versa
Change NLIO from Y to N in terminal profile
Change initially spooled in printer profile
Change HP 3000 characteristics:
• node name
• link name
• physical path of LANIC
Add X.25 card to DTC when none previously
existed
1. Use DTCCNTRL to shutdown/restart
DTS
2. Reboot DTC
You may also use TermDSM to reset
the DTC (see Troubleshooting
Terminal, Printer, and Serial Device
Connections for more information)
Task
Action Required for Change to Become
Active