Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

160 AppendixA
Error Messages
Validation Error Messages
Validation Error Messages
The network management configuration file must be validated before
automatic cross-validation with SYSGEN takes place.
The DTS validation procedure starts by displaying the following:
-> Validation of DTS/LINK started. <-
Errors are then listed. When the validation procedure is complete, it
will print the following:
nnn Encountered Errors
-> Validation of DTS/LINK finished. <-
where nnn is the total number of errors found during validation.
A numerical list of validation error messages and actions for each
follows.
Path: NMMGRpath — A read error encountered while reading the data
record (bad file). (DTSERR=3)
(DTSERR 3) Cause: Either a hardware problem occurred or the data record is too
long.
Action: Try to print the network management configuration file.
Rebuild the file from a copy of the sample file NMSAMP1.PUB.SYS. If the
problem persists, contact your Hewlett-Packard support representative.
Path: NMMGRpath — A write error encountered while updating the
data record (bad file). (DTSERR=4)
(DTSERR 4) Cause: Either a hardware problem occurred or the data record file is
too small.
Action: If the data record file has been compressed, it is impossible to
validate the file. Go to the UTILITY screen and use the compression
utility to make the file larger. Try to validate the file. If it still fails,
build the file from a copy of the sample file NMSAMP1.PUB.SYS. If the
problem persists when verifying the new file, contact your
Hewlett-Packard support representative.
Path: NMMGRpath — The data record is empty (use Update Data
function key). (DTSERR=5)
(DTSERR 5) Cause: The data record was not created for the NMMGRpath.
Action: Go back to the screen specified by the NMMGRpath and
update the screen.
Path: NMMGRpath — The same physical path is being used at
LINK.linkname. (DTSERR=6)
(DTSERR 6) Cause: The physical path specified for this link is being used.