Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

162 AppendixA
Error Messages
Validation Error Messages
Action: Go to one of the two screens and change the ldev number. The
ldev number must be unique for each port.
Path: NMMGRpath — LDEV #nnn is too big (must be <=4679).
(DTSERR=14)
(DTSERR 14) Cause: The logical device (ldev) number is bigger than the allowed
maximum ldev number.
Action: Go to the screen specified by the NMMGRpath and modify the
ldev number.
Path: NMMGRpath — Too many LDEVs are being used (must be
<=4649). (DTSERR=15)
(DTSERR 15) Cause: Too many logical device (ldev) numbers are being used.
Action: Review the screens that use ldevs and delete some ldev
numbers. The validation procedure allows a total of 4649 ldevs.
Path: NMMGRpath — Defined LINK.linkname is not being used.
(DTSWARN=17)
(DTSWARN 17) Cause: The defined linkname is not used by DTS or the network
interface.
Action: This is a warning only. No action is required.
Path: NMMGRpath — Too many links are being used (max. number
allowed = 8). (DTSERR=18)
(DTSERR 18) Cause: The link specified in the NMMGRpath cannot be processed. Too
many links are already defined.
Action: Go back to the DTS Configuration screen and delete the link
specified in the NMMGRpath. Delete all unused links so that eight or
less links are being used.
Path: NMMGRpath — Too many paths are being used (max. number
allowed = 8). (DTSERR=19)
(DTSERR 19) Cause: The link specified in the NMMGRpath cannot be processed. Too
many physical paths are already defined.
Action: Go back to the DTS Configuration screen and delete the link
specified in the NMMGRpath. Delete all unused links so that eight or
less links are being used.
Path: NMMGRpath — Too many DTCs are being used (max. number
allowed = 120). (DTSERR=20)
(DTSERR 20) Cause: The DTC specified in the NMMGRpath cannot be processed.
Too many DTCs are already configured.
Action: Go back to the DTC Configuration screen and delete the DTC
specified in the NMMGRpath.