Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

176 AppendixA
Error Messages
DCC Error Messages
Action: For DTC 72MX, the valid range for card number is 0 to 3. For
DTC 48, the valid range for card number is 0 to 5. For DTC 16, you may
use card 0 and 1 for connector cards and card 2 for X.25 card.
DCC ERROR P-L, Invalid DTC type specified, (DCC status SSSSSSSS.
(DCCERR=28)
(DCCERR 28) Cause: The NMCONFIG.PUB.SYS file may be corrupt.
Action: Use a backup configuration file, verify and update your
configuration, validate and cross-validate with SYSGEN, and restart
DTS. Keep the corrupt configuration file and report this condition to
your HP representative.
DCC ERROR P-L, DTC is not configured, NM path: NMMGRpath
(DCCERR=29)
(DCCERR 29) Cause: A dynamic configuration change was attempted on a DTC that
DCC has not yet created.
Action: Delete the DTC from the NMCONFIG file and run DTCCNTRL.
Then add the DTC back to the NMCONFIG.PUB.SYS file.
DCC ERROR P-L, Ldev is already configured, (ldev: LLL).
(DCCERR=30)
(DCCERR 30) Cause: The ldev #LLL is already configured on the system.
Action: Validate the NMCONFIG.PUB.SYS file and then cross-validate
with SYSTEM and then restart DTS.
DCC ERROR P-L, Duplicate node address or DTC node name.
NM path: NMMGRpath (DCCERR=31)
(DCCERR 31) Cause: The node address or DTC nodename of a DTC that was added
dynamically or automatically is already configured on an existing DTC.
Action: Verify the node address and nodename of the new DTC and
retry the operation. If the error occurs again, check the configurations
of the other DTCs that are in the NMCONFIG.PUB.SYS file. If the
duplicate entry is not found then restart DTS.
DCC ERROR P-L, DTC name is already configured. NM PATH:
NMMGRpath (DCCERR=32)
(DCCERR 32) Cause: The DTC name of a DTC that was added dynamically or
automatically is already configured.
Action: Verify that the DTC name doesn't already exist in the
NMCONFIG file. If the DTC name doesn't exist in the NMCONFIG file
then restart DTS or pick a different name for the DTC.
DCC WARNING P-L, Ldev not added to class. (HLIO status
SSSSSSSS, ldev LLL). (DCCWARN=33)