Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

182 AppendixA
Error Messages
DTCCNTRL Error Messages
Action: Reenter the command specifying a valid function in the FUNC
parameter. For example:
DTCCNTRL DTC=DTC.ITG.HP;CARD=4;FUNC=STARTX25
Valid functions are STARTX25, STARTPADSUP, STARTBOTH, RC,
STOPX25, STOPPADSUP, STOPBOTH, and STATUS.
ENCOUNTERED AN UNEXPECTED END-OF-LINE. (CIERR 10051)
PARAMETERS DO NOT MATCH USER COMMAND DEFINITION.
(CIERR 2039)
CIERR 10051 Cause: More parameters were entered than are defined by the
DTCCNTRL command. For example, the command was entered as:
DTCCNTRL
DTC=DTC.ITG.HP;CARD=4;FUNC=RC;FORCED=Y;RECONF=ALL;A=4
Action: Reenter the command without the invalid parameter. For
example:
DTCCNTRL
DTC=DTC.ITG.HP;CARD=4;FUNC=RC;FORCED=Y;RECONF=ALL
Failed to open the catalog file DTCCAT.PUB.SYS. (CTLERR 01)
CTLERR 01 Cause: The catalog file does not exist or could not be opened at the
time the command was executed.
Action: If the catalog file is missing or has been corrupted, try to
restore DTCCAT.PUB.SYS from the system backup. If this is not
successful, contact your Hewlett-Packard support representative.
Operator capability required to issue this command. (CTLERR 02))
CTLERR 02 Cause: A user without the proper capabilities attempted to issue a
DTCCNTRL command. OP capability is required.
Action: Obtain the required capabilities and reissue the command.
Invalid function specified in FUNC. (CTLERR 03)
CTLERR 03 Cause: The FUNC parameter was not a valid DTCCNTRL function.
Action: Reenter the command specifying a valid function in the FUNC
parameter. For example:
DTCCNTRL DTC=DTC.ITG.HP;CARD=4;FUNC=STARTX25
Valid functions are STARTX25, STARTPADSUP, STARTBOTH, RC,
STOPX25, STOPPADSUP, STOPBOTH, and STATUS.
System is not Host-Based X.25. (CTLERR 04)
CTLERR 04 Cause: The DTCCNTRL command was issued on a system that is not
configured as a host-based X.25 system (either the system is PC-based
or it is host-based but is not configured for X.25 connections).