Configuring and Managing Host-Based X.25 Links - Edition 5 (36939-90054)

Chapter 3 61
Configuring DTCs Step-by-Step
Modify the Network Management Configuration File
PAD access
password
(optional) A password, up to eight alphanumeric characters in
length, that will be required when users connected to
this DTC via a PAD device attempt to establish a
communication link.
To configure
a card, enter
a card number
then press
Config Card This parameter determines the next screen that will
appear after you have saved the data configured on the
screen. Enter the number of the card you want to
configure and press the
[Config Card] key.
Step 7: Configure DTC Cards
When you press the [Config Card] key at the DTC Configuration screen,
NMMGR will display the corresponding card configuration screen for
the specified card in the DTC. Figure 3-6 shows an example of a Card
Configuration screen for DTC 72MX for asynchronous connect card.
(Screens vary slightly for DTC 16iX/16MX/16RX, DTC 16, and DTC 48).
The corresponding screen for a DTC 16iX/16MX/16RX is called a Port
Configuration Screen since DTC 16iX/16MX/16RX has port connectors
built directly onto the backplane and does not have connector cards.
Use this screen to configure the ports in the specified card. On this
screen, logical device (ldev) numbers and profile names are associated
with individual ports on the card.