HP System Dictionary/XL SDMAIN Reference Manual (32256-90001)

A-166
CAUSE The SINGLE-SPACE keyword is used and the DOUBLE-SPACE keyword ignored.
ACTION No action is needed. The next time the command is issued, specify only one spacing
option.
1309 MESSAGE DOUBLE-SPACE used instead of PAGE (SDWARN 1309)
CAUSE The DOUBLE-SPACE keyword is used and the PAGE keyword ignored.
ACTION No action is needed. The next time the command is issued, specify only one spacing
option.
1310 MESSAGE Default margins and report page-length are incompatible (SDWARN 1310)
CAUSE The output file and page-length fields cannot be reassigned while in a nested report
(you do not want output sent to different files or have the page length changing within
a file while in the same report). When the values for these fields are reset to their
default values, they are not compatible with the page defined by the top level report.
ACTION No action is required as the margins and page-length of the top level report are used.
The incompatibility should be checked to make sure the various levels of the report are
all set up to write to the same size paper.
Define Messages (1325-1349)
1325 MESSAGE The ! keyword is ignored in customization mode (SDWARN 1325)
CAUSE The indicated keyword is not allowed if the open mode of the dictionary is going to be
CUSTOMIZATION.
ACTION Do nothing as the clause is ignored. The next time the dictionary is open in
CUSTOMIZATION mode, do not specify this keyword.
1326 MESSAGE Both VERSION and STATUS were specified. STATUS is ignored (SDWARN
1326)
CAUSE Both the VERSION and STATUS keyword cannot be specified in the same command.
Either VERSION for a specific version or STATUS for the last version of the given
status should be used.
ACTION Do nothing as the version will be used and the status ignored. The next time the
dictionary is opened, specify either a specific version (VERSION) or a specific status
(STATUS) but not both.
1327 MESSAGE Quoted passwords cannot extend to multiple lines (SDERR 1327)
CAUSE If the password is entered within quotes it must be entered on a single line.
ACTION Specify the password so that the opening and closing quotes are on the same line.
1328 MESSAGE Invalid scope password. Remember case counts (SDWARN 1328)
CAUSE An invalid password has been entered in response to the scope password prompt.
Remember, System Dictionary distinguishes between uppercase and lowercase
characters in a scope password.
ACTION Specify the correct password for the scope.
1329 MESSAGE Exceeded maximum tries for a valid scope password (SDERR 1329)