MPE/iX Quick Reference Guide (32650-90881)

64 Chapter2
Utilities
Utilities Descriptions
Utilities Descriptions
Brief descriptions of the utilities available for MPE/iX.
ASOCTBL
Use the ASOCTBL utility to distribute operator commands for specific devices to standard
MPE/iX users. This utility creates a table that associates users with device classes in a file
called ASOCIATE.PUB.SYS. Users gain access to the corresponding device class with the
ASSOCIATE command. The user then has exclusive access to the operator commands that
control that device until their association is terminated by logging off or issuing the
DISASSOCIATE command. In ASOCTBL, > is the prompt.
AUTOINST
See the System Software Maintenance Manual for information on this utility.
BULDACCT
BULDACCT runs only on MPE/iX. Use it to take a snapshot of the directory structure on the
source system, then recreate it on the destination system. Use BULDACCT to migrate a set of
accounts from one volume set to another.
BULDACCT has been enhanced to work with MPE/iX hierarchical directory structures. The
hierarchical directory information for accounts, groups, and users is written to BULDJOB1.
BULDJOB1 contains the commands used to recreate hierarchical directories and the ACDs
associated with each of them.
BUILDINT
Use the BUILDINT utility to build or change compatibility mode (CM) intrinsic disk files.
BUILDINT accepts SPL procedure head declarations (OPTION EXTERNAL is required) and
optional commands as input data. If no commands are issued, the procedure head
declarations are added to the intrinsic file. Any input data that is not a procedure head
terminates input; at this point, the program prints a formatted list of all intrinsics and
terminates.
ASOCTBL
>
devclass = username.acctname
|
or
RUN ASOCTBL.PUB.SYS
>
devclass = username.acctname
|
or
BULDACCT
BULDACCT;INFO="
processing_opt
ions
"
BULDACCT:
processing_options
RUN BUILDINT.PUB.SYS
or
BUILDINT