MPE/iX System Utilities Reference Manual (32650-90908)

Chapter 9
FSCHECK
Operation
108
DEBUG
The DEBUG command invokes the native mode system.
Syntax
DEBUG
Parameters
None
Example
fscheck: DEBUG
Return
DISPLAYLABEL [DL]
The DISPLAYLABEL command displays the fully qualified file name and offset within the label table for each
file label entry of the label table on the specified logical device.
Syntax
DISPLAYLABEL [DEV=] ldev
set_name
ALL
Parameters
DEV= DEV= is an optional keyword for the parameter. If it is omitted, the default is to display the
contents of the label table for each mounted volume of the system volume set.
ldev Ldev is a number from 1 to 32,767, specifiying the logical device on which the volume is
mounted. The volume must be mounted in the master or member state, as displayed by the
DSTAT command.
set_name Set_name is the name of a mounted volume set whose master volume is mounted in the
MASTER state as displayed by the DSTAT command. For each mounted volume in the set,
the contents of the label table is displayed.
ALL ALL displays the contents of the label table for each volume mounted in the MASTER or
MEMBER state, as determined by the DSTAT command.
Example
fscheck: DISPLAYLABEL DEV=1
Return