MPE/iX System Utilities Reference Manual (32650-90908)

Chapter 20
SAINT
Operation
170
ACTION You may try and use the PME or change the linker commands used to build the NL that is
the source of the PME. The linker commands that affect the location of the pages are the
limit option on the buildxl command and the cleanxl command.
Internal ERROR. Attempt to read or write with index < 0
CAUSE SAINT has attempted to read or write a file using an invalid index. This is an error in an
input file or an internal error.
ACTION If an input file is indicated, check the input file for correct format and contents; otherwise
enter an SR and provide a copy of all the input files, the SAINT program, and any output file.
An IMPORT STUB entry point was not found in the library
CAUSE One of the SOMs within the library (the NL loaded by SAINT loadsyslib command) has
made a call to a procedure external to itself, and no other SOM in the library contains the
procedure.
ACTION Find out which SOM the called procedure should reside in (that is, console SOM, diagnostic
SOM, and so on) and try relinking the library with another version of the SOM.
An SXRT entry point symbol was not found in the library
CAUSE A procedure or intrinsic name in the DSXRT file (loaded by SAINT loadsxrt command) has
no corresponding code in the library (the NL loaded by SAINT loadsyslib command).
ACTION First make sure that the correct version of the DSXRT file is being used for the library. Once
this has been verified, it is most likely that the warning message can be ignored. Sometimes
obsolete entries are left in the DSXRT file but have no effect on system operation; however,
if a warning message exists and the system is experiencing other problems (for example,
will not boot), further diagnosis may be necessary. Contact the factory.
ERROR on move data, file num = xx escape code = yyyyyyy
CAUSE When SAINT attempts to move data into a file and an error is detected by the operating
system a trap code is returned to SAINT. There will be further error messages that will
define the problem.
ACTION Determine the problem from the messages that follow.
Error - OUT OF DISK SPACE or internal pointer error
CAUSE The most common cause of this error is out of disk space. The other possible cause is that an
internal pointer has an invalid value in it.
ACTION First make sure that there is enough disk space on the volume set where the file is being
written. Next check the limits on the group and account where the file is being written. The
file name is in the
+-F-I-L-E—-I-N-F-O-R-M-A-T-I-O-N—-D-I-S-P-L-A-Y-+.
Correct the disk space problem. If there is enough disk space and the problem still exists,
enter an SR describing the problem. Send supporting material: a store tape with a copy of
all files used as input to SAINT, (NL,CME, DSXRT,EXTMILLI) a copy of the PME written,
and the SAINT program.
Error - Unknown internal pointer error
CAUSE An internal pointer has an invalid value in it. The file name is in the
+-F-I-L-E—-I-N-F-O-R-M-A-T-I-O-N—-D-I-S-P-L-A-Y+.