MPE/iX System Utilities Reference Manual (32650-90908)

Chapter 28
TERMDSM
Operation
219
Reset
Reset resets a DTC, SIC or port. When the Reset command is entered the system responds with the
following:
(reset)
Ldev #
POrt #,#,#
SIc #,# (multiplexer card in DTC)
DTc #
(carriage return to exit) ?
Parameters are DTC, SIC and port for POrt and DTC and SIC for SIc. Other parameters are as indicated.
Security is 1 for Ldev’s and ports; 0 for DTC’s or SIC’s.
CAUTION Active sessions are logged off reset devices.
Status
STatus displays information about the DTC or port. When STatus is entered the system responds by
displaying:
(status)
DTc #
POrt #,#,#
(carriage return to exit) ?
The parameter for POrt is DTC, SIC and port number.
DTc displays the system’s DTC’s. It provides the same information provided when TERMDSM is initiated.
Help displays informtion about TERMDSM.
EXit terminates the TERMDSM subsystem.
Additional Discussion
For more information refer to Troubleshooting Terminal, Printer, and serial Device Connections.