MPE/iX System Utilities Reference Manual (32650-90908)

UPSUTIL for MPE/iX
UPSUTIL Commands
Chapter 32
246
UPS Monitor Operating State : Running (PIN = 78)
UPS Monitor Version Number : 9 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : Console only. 3 UPS Devices Allocated
Configuration File Name : UPSCNFGB.PUB.SYS ( Config File Ok )
Powerfail Command File Name : $null ( Pfail Cmd File Ok )
Powerfail Command File Parms: none
Powerfail Grace Period (secs: 0
Powerfail Grace Timer : Not Running.
Powerfail Command File : Not Running.
Action on UPS Low Battery : Keep Running
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
----------------------------------------------------------------------------
UPSUTIL: Command >
Example #3 — Error in Configuration File
The final example shows what happens when an error is detected in an UPS Monitor configuration file. In
this case, the configuration file UPSCNFGC.PUB.SYS was attempting to set the powerfail message routing to
“all terminals”, but there was a typographic error in the “all terminals” parameter. The UPS Monitor reports
the error to the system console, and the UPSUTIL STATUS command shows that the UPS Monitor has found
an error in the current configuration file, UPSCNFGC.
----------------------------------------------------------------------------
UPSUTIL: Command > newconfig
----------------------------------------------------------------------------
Begin SET NEW CONFIG FILE UPS Monitor operation
Enter the file name of the new configuration file (file.group.account)
New config file name? upscnfgc.pub.sys
12:09/52/Illegal configuration command parameter in UPS Monitor