MPE/iX System Utilities Reference Manual (32650-90908)

UPSUTIL for MPE/iX
UPSUTIL Commands
Chapter 32
248
STATUS Command
The STATUS command causes UPSUTIL to query the UPS Monitor Process for its status and for the status
of each configured UPS device, and to display the status information reported by the UPS Monitor process.
Syntax
status
Example #1 — Normal Status
--------------------------------------------------------------------------
UPSUTIL: Command > status
----------------------------------------------------------------------------
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS:
UPS Monitor Operating State : Running (PIN = 196)
UPS Monitor Version Number : 9 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : All terminals. 3 UPS Devices Allocated
Configuration File Name : UPSCNFIG.PUB.SYS ( Config File Ok )
Powerfail Command File Name : MYPFAIL.PUB.SYS ( Pfail Cmd File Ok )
Powerfail Command File Parms: none
Powerfail Grace Period (secs: 300
Powerfail Grace Timer : Not Running.
Powerfail Command File : Not Running.
Action on UPS Low Battery : Keep Running
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 101 Yes Yes Monitoring Normal AC Power Normal
3 103 Yes Yes Monitoring Normal AC Power Normal
End display of UPS Monitor status.
----------------------------------------------------------------------------
UPSUTIL: Command >