MPE/iX System Utilities Reference Manual (32650-90908)

UPSUTIL for MPE/iX
UPSUTIL Commands
Chapter 32
261
In this case, as in Example #6 when initialization was not yet completed, the UPS Monitor Process does not
know what the power status or hardware status of the UPS device is, so the STATUS display shows “???” for
those fields.
NOTE If a UPS device is put into the “Down/Broken” state by the UPS Monitor Process, then the UPS
Monitor Process must be restarted (after repairing the problem that has caused the loss of
communications with the UPS device) in order to resume monitoring of that UPS device.
--------------------------------------------------------------------------
UPSUTIL: Command > status
--------------------------------------------------------------------------
Begin display of UPS Monitor status.
UPS MONITOR PROCESS STATUS:
UPS Monitor Operating State : Running (PIN = 196)
UPS Monitor Version Number : 9 3 UPS Devices Configured
System Power State : Power is normal. 3 UPS Devices Monitored
Powerfail Recovery Messages : All terminals. 3 UPS Devices Allocated
Configuration File Name : UPSCNFIG.PUB.SYS (Config File Ok)
Powerfail Command File Name : MYPFAIL.PUB.MYACCT (Pfail Cmd File Ok)
Powerfail Command File Parms: [inventory_data_set orders_data_set]
Powerfail Grace Period (secs: 300
Powerfail Grace Timer : Not Running.
Powerfail Command File : Not Running.
Action on UPS Low Battery : Keep Running
UPS DEVICES STATUS:
UPS# Ldev# Alloc Init State Power Hardware Status
~~~~ ~~~~~~ ~~~~~ ~~~~ ~~~~~~~~~~~~ ~~~~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
1 22 Yes Yes Monitoring Normal AC Power Normal
2 23 Yes Yes Monitoring Normal AC Power Normal
3 24 Yes No Down/Broken ??? ???
End display of UPS Monitor status.
--------------------------------------------------------------------------
UPSUTIL: Command >