NS3000/iX Error Messages Reference Manual (36923-90043)

104 Chapter10
Network Transport Protocol (PMERR) Error Messages
ACTION: None. For notification purposes only.
21 MESSAGE: SHUTDOWN COMPLETE
CAUSE: The graceful release shutdown for the connection has been
completed. The connection has been released.
ACTION: None. For notification purposes only.
22 MESSAGE: IPC SHUTDOWN COMPLETE
CAUSE: The connection has been terminated by IPC.
ACTION: None. For notification purposes only.
-10 MESSAGE: FIN BEFORE OPEN
CAUSE: TCP has had an internal error which has caused it to process an
inbound FIN packet before the open handshake with IPC was complete.
ACTION: This is an internal error. See Appendix A , “Submitting a CR,”
of this manual. A protocol level trace of TCP header information will
enhance resolution of this defect.
-11 MESSAGE: LOOPBACK FRAGMENTATION
CAUSE: A message for a loopback connection in message mode was
fragmented.
ACTION: This is an internal error. See Appendix A , “Submitting a CR,”
of this manual. A protocol level trace including buffer and message level
tracing will enhance resolution of this defect.
-12 MESSAGE: Network Type Manager (NWTM) Error
CAUSE: A call to a Network Type Manager procedure returned an error
status.
ACTION: Enable class 2 logging for NS Transport if not previously
enabled. Locate matching log instance for Network Type Manager
Error. Error message will indicate class 2, subsystem 3, entity TCP,
location 100xx. Parameter is NWTM error returned. (Sign bit set indicates
error, not set indicates warning.) Consult NWTM error documentation if
available, submit an CR with this information if necessary.
-13 MESSAGE: SEND MESSAGE (Ports) ERROR
CAUSE: A call to a port send message procedure returned an error
status.
ACTION: Enable class 2 logging for NS Transport if not previously
enabled. Locate matching log instance for send message error. Error
message will indicate class 2, subsystem 3, entity TCP, location 101xx.
Parameter is ports error returned. (Sign bit set indicates error, not set
indicates warning.) Consult MPE/iX operating system error
documentation if available, submit an CR with this information if
necessary.