NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 12 117
NETXPORTERR Error Messages
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
4009 MESSAGE: BOTH START AND STOP ISSUED.
CAUSE: Both parameters not allowed in a single NETCONTROL command.
ACTION: Pick appropriate command. Correct and retry.
4011 MESSAGE: INVALID TRACE TYPE. EXPECTED COMBINATION OF
D,H,M,B,N,S.
CAUSE: Usually a typographical error. Recommended combination for
trace type is HMD.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
4012 MESSAGE: INVALID TRACE DESTINATION. EXPECTED DISC.
CAUSE: Usually a typographical error. DEFAULT: Disk.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
4013 MESSAGE: INVALID FILE NAME.
CAUSE: An invalid file name has been supplied with the NETCONTROL
TRACEON option. Usually a typographical error.
ACTION: Check the NS 3000/iX Operations and Maintenance
Reference Manual for proper syntax. Correct and retry.
4014 MESSAGE: INVALID RECORD SIZE, MUST BE >5 AND 1024.
CAUSE: Trace file record size specified in command line parameter is too
large or too small.
ACTION: Correct with valid value; retry.
4015 MESSAGE: INVALID FILE SIZE, MUST BE > THAN 32 AND 32000.
CAUSE: Trace file size specified in command line parameter is too large
or too small.
ACTION: Correct with valid value; retry.
4016 MESSAGE: CONTROL PROCESS NOT STARTED (NMERR= ! ).
CAUSE: NMMON was unable to launch the Control Process, or user
issued a command when the transport was not active.
ACTION: Issue NETCONTROL START. Then retry command. If problem
persists, see Appendix A , “Submitting a CR,” of this manual.
4017 MESSAGE: DATA DICTIONARY FULL, TRY AGAIN.
CAUSE: Data dictionary full.