NS3000/iX Error Messages Reference Manual (36923-90043)

118 Chapter12
NETXPORTERR Error Messages
ACTION: Reissue the command after waiting a few minutes. If the
problem persists, then see Appendix A , “Submitting a CR,” of this
manual.
4021 MESSAGE: TRACE OPEN ERROR.
CAUSE: Usually, you are trying to open a trace on an already opened
trace file.
ACTION: Ensure that the trace file exists and is open. If it exists and is
not open, then see Appendix A , “Submitting a CR,” of this manual.
4023 MESSAGE: BAD DIAG VALUE, EXPECTED SET(0–31) OR RST(0–31).
CAUSE: Invalid DIAG value.
ACTION: The DIAG keyword command is not for customer use. Contact
your Hewlett-Packard representative.
4025 MESSAGE: NET NOT ALLOWED WITH PROT.
CAUSE: The two entities (NET and PROT) cannot be used together.
ACTION: Pick appropriate entity and reissue command.
4026 MESSAGE: EXPECTED VERSION KEYWORD MOD.
CAUSE: User typed an illegal command.
ACTION: Type word MOD after VERSION=.
4028 MESSAGE: FOPEN FAILED ON NETMSG.NET.SYS.
CAUSE: Usually appears with an MPE XL command.
ACTION: Fix the MPE XL error. Ensure that the NETMSG file exists; if it
does, then see Appendix A , “Submitting a CR,” of this manual.
4029 MESSAGE: MESSAGE CATALOG ERROR ON NETMSG.NET.SYS.
CAUSE: Usually appears with an MPE XL command.
ACTION: Fix the MPE XL error. Ensure that the NETMSG file exists; if it
does, then see Appendix A , “Submitting a CR,” of this manual.
4030 MESSAGE: GATE &NET FUNCTIONS ENTERED, ONLY ONE
ALLOWED.
CAUSE: The GATE and NET keywords have been specified on the same
NETCONTROL command line.
ACTION: Reissue the NETCONTROL command using only one of the
keywords.
4031 MESSAGE: TRACEON AND TRACEOFF NOT ALLOWED ON SAME
LINE.
CAUSE: The TRACEON and TRACEOFF keywords have been specified on
the same NETCONTROL command line.