NS3000/iX Error Messages Reference Manual (36923-90043)

120 Chapter12
NETXPORTERR Error Messages
4044 MESSAGE: VERSION ERROR: BAD MODULE (S).
CAUSE: There may be no version stamp; file label may be overwritten,
or possible bad software installation.
ACTION: See Appendix A , “Submitting a CR,” of this manual.
4045 MESSAGE: ALREADY STARTED.
CAUSE: NETCONTROL START command issued for an already active
entity.
ACTION: None.
4046 MESSAGE: NOT STARTED.
CAUSE: The NETCONTROL STOP command was issued when the network
transport was never running.
ACTION: Check the command for correctness. If it is correct, no further
action is required.
4047 MESSAGE: TOO MANY MESSAGES TO BE DISPLAYED.
CAUSE: The NETCONTROL error reporting mechanism has encountered
more than 6 errors.
ACTION: Fix the errors displayed and try the command again. If this
error persists, submit and CR. See Appendix A , “Submitting a CR.”
4048 MESSAGE: ! PROTOCOL IS NOT ACTIVE.
CAUSE: Trace issued on an inactive protocol.
ACTION: Check configuration file. All protocols must be configured.
4049 MESSAGE: THIS COMBINATION OF FUNCTIONS AND OBJECTS NOT
ALLOWED.
CAUSE: Certain NETCONTROL functions and entities are mutually
exclusive and cannot be combined on the same command line. Multiples
of the same function are not allowed.
ACTION: Check NS 3000/iX Operations and Maintenance Reference
Manual for proper syntax. Correct and retry.
4050 MESSAGE: niName NOT CONFIGURED.
CAUSE: The NI named is not configured.
ACTION: Alter the configuration file appropriately, shut down the
transport, and reconfigure.
4051 MESSAGE: NAME LONGER THAN 8 CHARACTERS.
CAUSE: Usually a command line syntax error.
ACTION: Rename if necessary; retype and retry.