NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 12 121
NETXPORTERR Error Messages
4052 MESSAGE: COMMAND NOT EXECUTED DUE TO VERSION
MISMATCH.
CAUSE: Missing software modules or module version number mismatch.
ACTION: Issue the NETCONTROL VERSION=MOD command for more
information. See Appendix A , “Submitting a CR,” of this manual.
4053 MESSAGE: ! DEVICE NOT CONFIGURED.
CAUSE: The link name specified with the ADDLINK or DELLINK keyword
in the NETCONTROL command line is not configured.
ACTION: Check the command for correctness. If it appears correct and
the link is configured correctly, see Appendix A , “Submitting a CR,” of
this manual.
4054 MESSAGE: THE ENTITY IS NOT ACTIVE.
CAUSE: Issued a NETCONTROL STATUS command on an inactive entity.
ACTION: None.
4055 MESSAGE: INTERNAL ERROR ON STATUS, TRY AGAIN.
CAUSE: NETCONTROL STATUS error.
ACTION: Wait and try again; if problem persists, see Appendix A ,
“Submitting a CR,” of this manual.
4056 MESSAGE: ! DEVICE ALREADY STARTED.
CAUSE: The link name specified by the NETCONTROL ADDLINK command
has already been started.
ACTION: Check the command for correctness. If it appears correct, no
further action is required.
4057 MESSAGE: ! DEVICE NOT STARTED.
CAUSE: The link name specified by the NETCONTROL DELLINK command
is already shut down.
ACTION: Check the command for correctness. If it appears correct, no
further action is necessary.
4058 MESSAGE: X25 NOT INSTALLED.
CAUSE: An attempt was made to start an X25 network when X25 is not
installed on the system.
ACTION: Install X25. If X25 is properly installed then see “Appendix A ,
“Submitting a CR,” of this manual.
4059 MESSAGE: BAD UPDATE VALUE, EXPECTED INTERNET OR
MAPPING.
CAUSE: Something other than the supported INTERNET or MAPPING
option follows the UPDATE= option in the NETCONTROL command line.