NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 14 133
VALERR and VALWARN Messages
ACTION: Correct one of the two addresses such that their network
portions match.
20 MESSAGE: THIS LINK IS NOT ALLOWED FOR THIS NI TYPE.
CAUSE: You are configuring a LAP-B network interface link, but the
link name specified corresponds to a non-LAP-B link.
ACTION: Reconfigure the link in the Link Selection screen (LINK) as a
LAP-B link type.
25 MESSAGE: SECURITY ENABLED BUT NO SECURITY STRING
CONFIGURED.
CAUSE: The Dial Protocol screen is configured with Security On = Y but
there are no security strings configured.
ACTION: Either disable security in the Dial Protocol Screen, or
configure at least one security string.
26 MESSAGE: HOME NETWORK NAME MUST NOT BE GATEWAY HALF.
CAUSE: The specified home network name in the Global Transport
configuration screen corresponds to a configured gatehalf type network
interface.
ACTION: Check the names of the network interfaces configured in
NETXPORT.NI. Except for loop and gatehalf types, enter one of the
configured network interfaces as the home network name on the Global
Transport Configuration Screen (NETXPORT.GLOBAL).
27 MESSAGE: HOME NETWORK NAME MUST NOT BE LOOPBACK.
CAUSE: The specified home network name in the Global Transport
configuration screen corresponds to configured loopback type network
interface.
ACTION: Check the NI names configured in NETXPORT.NI. Choose one of
the names that does not correspond to a LOOPBACK type.
28 MESSAGE: NO MAPPING ENTRIES CONFIGURED FOR ROUTER NI.
CAUSE: There are no entries configured on the Router Mapping Screen.
ACTION: Configure mapping entries for the Router NI
(NETXPORT.NI.NIname.MAPPING).
30 MESSAGE: MUST CONFIGURE A HOME NETWORK — GATEHALF NI
IS CONFIGURED.
CAUSE: A home network is not configured on the Global Transport
Screen, but a gatehalf network interface is configured.
ACTION: Check the names of the NI configured. Choose one of the
names that does not correspond to a gatehalf type.