NS3000/iX Error Messages Reference Manual (36923-90043)

134 Chapter14
VALERR and VALWARN Messages
31 MESSAGE: CONFIGURED REACHABLE NETS (n) MUST BE = IPU
MAX NETS (m).
CAUSE: The maximum number of internet reachable networks
configured for the specified network interface exceeds the maximum
number of networks.
ACTION: Use the NMMGR utility to reduce the number of reachable
networks in NETXPORT.NI.NIname.INTERNET.gatename to be equal to
or less than the maximum value. Validate the configuration again.
32 MESSAGE: CONFIGURED GATEWAYS (n) MUST BE = IPU MAX
GATES (m).
CAUSE: The number of gateways configured for the specified
NETXPORT.NI.NIname.INTERNET screen is greater than the maximum
value permitted.
ACTION: Use the NMMGR utility to reduce the number of gateways in
NETXPORT.NI.NIname.INTERNET to be equal to or less than the
maximum value. Validate the configuration again.
33 MESSAGE: CONFIGURED MAPPINGS (n) MUST BE = NUMBER OF
ROUTER TABLE ENTRIES (m).
CAUSE: The number of configured entries on the Router Mapping screen
exceeds the maximum number of router table entries.
ACTION: Use the NMMGR utility to reduce the number of mappings in
NETXPORT.NI.NIname.MAPPING to be equal to or less than the
maximum value. Validate the configuration again.
34 MESSAGE: NO CORRESPONDING NI LINK CONFIGURED.
CAUSE: The link name entered in the Router Mapping Screen differs
from any configured in the NI Link Screen.
ACTION: Make sure that the link name specified in the Router Mapping
Screen is the same as one of the links configured in the NI Screen
(NETXPORT.NI.NIname.LINK).
35 MESSAGE: IP NETWORK NUMBER IN RECORD DOESN’T MATCH NI
IP NETWORK NUMBER.
CAUSE: The network portion of the IP internet address specified in the
network interface mapping screen differs from the network portion of
the IP internet address configured in the IP Protocol Screen.
ACTION: Make sure that the IP network number in the Mapping Screen
(NETXPORT.NI.NIname.MAPPING) is the same as the IP number
specified in the IP Protocol Screen
(NETXPORT.NI.NIname.PROTOCOL.IP).
37 MESSAGE: LINKTYPE MUST BE LAN802.3 IN LINK.
CAUSE: The NI type is LAN802.3, but the link configured corresponds