NS3000/iX Error Messages Reference Manual (36923-90043)

138 Chapter14
VALERR and VALWARN Messages
108 MESSAGE: NO PHONE NUMBER REQUIRED FOR DC LINK.
CAUSE: Phone data has been erroneously configured for a direct connect
link.
ACTION: Delete the phone data, or correct the link type.
109 MESSAGE: LOOPBACK ONLY CONFIGURATION NOT ALLOWED.
CAUSE: Loopback is the only NI configured.
ACTION: Use NMMGR to add NIs for LAN or router networks and
validate the Network Transport again.
110 MESSAGE: LINK TYPE MUST BE X.25 IN LINK CONFIGURATION.
CAUSE: The link specified in the NETXPORT.NI.NIname.LINK.linkname
is not configured as an X.25 link.
ACTION: Use NMMGR to change the link type in LINK.linkname to an
X.25, or create a new link of type X.25 and associate it with this
NIname. Validate the network transport configuration again.
111 MESSAGE: MUST CONFIGURE A NODE NAME.
CAUSE: There is no node name configured under the NODENAME path.
ACTION: Use NMMGR to configure a local node name under the
NODENAME path.
112 MESSAGE: NOT A VALID LOGGING CLASS FOR SUBSYSTEM 40.
CAUSE: A class other than CLAS0000, CLAS0001, CLAS0002,
CLAS0003, CLAS0004, or CLAS0005 has been configured as a logging
class for subsystem 40 (remote link manager).
ACTION: Use NMMGR to change the configuration file so that only
valid classes are configured. Validate the network transport
configuration again.
113 MESSAGE: SUBSYSTEM 40 LOGGING NOT CONFIGURED.
CAUSE: The LOGGING.SUB0040 record does not exist in the configuration
file.
ACTION: Use NMMGR and go to the LOGGING screens to add the
LOGGING.SUB0040 record to the configuration. Logging classes 0000
through 0005 should also be added to the configuration so that logging
is completely configured for Remote Link Management.
114 MESSAGE: FIVE LOGGING CLASSES REQUIRED FOR
SUBSYSTEM 40.
CAUSE: All required logging classes are not configured for
subsystem 40. Six logging classes configured: CLAS0000, CLAS0001,
CLAS0002, CLAS0003, CLAS0004, CLAS0005.