NS3000/iX Error Messages Reference Manual (36923-90043)

158 Chapter15
LAN, LAN/Console, Token Ring LAN Error Messages
151 MESSAGE: Unexpected timer event message.
CAUSE: Unknown. Need more information.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
152 MESSAGE: Unimplemented message received.
CAUSE: The message descriptor is not known to the driver.
ACTION: Call your Hewlett-Packard representative and explain what
you are trying to do.
160 MESSAGE: Nil configuration pointer.
CAUSE: A user passed a nil configuration pointer to the driver.
ACTION: Call your Hewlett-Packard representative and explain what
you are trying to do.
161 MESSAGE: Trace manager overrun.
CAUSE: The driver is generating trace entries faster than the trace
manager can process them. This causes some trace entries to be lost.
ACTION: This is only a warning and is indicative of a very busy system.
If not debugging a problem, then tracing should be turned off. This will
improve system performance in general. If a problem is being looked at,
use partial tracing whenever possible (when full data frames are not
needed) to ensure that no trace data is lost.
224 MESSAGE: Could not read the link name from the LSS link table.
CAUSE: The link table does not exist.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard representative.
225 MESSAGE: Could not add the link name to the LSS link table.
CAUSE: The link table does not exist.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard representative.
226 MESSAGE: Could not delete the link name from the LSS link table.
CAUSE: The link name specified the LAN_KILL_MODULE call is not in the
LSS link table.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
227 MESSAGE: Could not read multicast addresses table.
CAUSE: The multicast addresses table does not exist.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard representative.