NS3000/iX Error Messages Reference Manual (36923-90043)

160 Chapter15
LAN, LAN/Console, Token Ring LAN Error Messages
235 MESSAGE: A call to IO_UNCONFIG failed during driver
deconfiguration.
CAUSE: Wrong physical path was specified in IO_UNCONFIG call due to
configuration data corruption in the driver PDA.
ACTION: Write down the error information displayed on the console,
submit an CR, take a system dump, and call your Hewlett-Packard
representative.
236 MESSAGE: The LAN card is used by another link.
CAUSE: The card was configured by another link.
ACTION: Use NMMGR to correct the Physical Path for this link or
change the link name to point to a different LAN card.
237 MESSAGE: Could not create inbound buffer pool for the CIO LAN
card.
CAUSE: The buffer manager cannot allocate a new logical buffer pool
entry or cannot allocate virtual memory for the buffers.
ACTION: Write down the error information displayed on the console and
call your Hewlett-Packard representative.
238 MESSAGE: Could not delete the CIO LAN card inbound buffer pool.
CAUSE: Wrong pool ID was specified in the call to delete inbound buffer
pool due to configuration data corruption in the driver’s PDA.
ACTION: Write down the error information displayed on the console
submit an CR, take a system dump, and call your Hewlett-Packard
representative.
239 MESSAGE: Could not open trace file.
CAUSE: The indicated trace file might be opened with exclusive access.
ACTION: Wait for the program or process that has the trace file opened
exclusively to close it.
240 MESSAGE: Could not stop trace.
CAUSE: Tracing might have been turned off with LINKCONTROL
TRACEOFF command, but the link software information indicates that it
was on.
ACTION: Ignore this problem unless you are experiencing other
problems. If you are experiencing other problems, write down the error
information displayed on the console and call your Hewlett-Packard
representative.
241 MESSAGE: Could not start trace.
CAUSE: Unknown. Need more information.