NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 16 165
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Generic Status Values
7 ($07) MESSAGE: Inadequate resources available to satisfy a request.
CAUSE: There are inadequate SAP control block, buffers, or link
stations available to satisfy the request.
ACTION: According to the situation, close some SAPs/stations or wait.
8 ($08) MESSAGE: An adapter card is not responding.
CAUSE: The driver detects an exception in hardware operation. At this
state, the only type of requests that would be processed are the
diagnostic requests or Module Deconfigurator Call.
ACTION: Stop the normal operation and execute the diagnostic
software.
29 ($41) MESSAGE: Could not establish requested connection, but can retry.
CAUSE: The Connect Request could not establish a requested
connection, however, it is a recoverable situation.
ACTION: Start a timer and try again when timer popped.
42 ($2A) MESSAGE: Could not establish requested connection, cannot retry.
CAUSE: The Connect Request could not establish a requested
connection and it is not a recoverable situation.
ACTION: Determine the cause for the failure and try again when
resolved.
43 ($2B) MESSAGE: Could not establish requested connection, no remote
response.
CAUSE: The Connect Request could not establish a requested
connection.
ACTION: Check the configuration and make sure the remote system is
up and running.
44 ($2C) MESSAGE: Remote connections are still active.
CAUSE: For the Separate Request, there are connections still active on
the LSAP, the driver did not close the LSAP or disconnect the
associated connections.
ACTION: Disconnect all the associated connections and try again.
45 ($2D) MESSAGE: Link has lost its connection to the remote link.
CAUSE: After the link has been established and both link stations are in
open state, a link station detected an inoperative condition in either the
remote link station or in the transmission medium (the recovery
attempt has failed). The driver informs the user that link is inoperative,
also, no link station resource has been deallocated.
ACTION: Send a Disconnect Request to the Driver and log the error.