NS3000/iX Error Messages Reference Manual (36923-90043)

168 Chapter16
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Generic Status Values
ACTION: Fix the configuration file and try again.
126 ($7E) MESSAGE: Link type of the named link is not supported.
CAUSE: The linktype that stored in the NMCONFIG file which
associated with the Linkname in a Module Configurator call is
unsupported. The particular driver is not configured.
ACTION: Fix the Configuration file and try again.
127 ($7F) MESSAGE: An invalid subsystem open ID was specified.
CAUSE: The Open ID in the Rendezvous Request or Module
Deconfigurator call is invalid. The LSAP is not opened or closed.
ACTION: Use a Valid open ID.
128 ($80) MESSAGE: An invalid protocol bind ID was specified.
CAUSE: The requested Protocol Bind ID does not exist.
ACTION: Make the appropriate changes and reissue the request.
129 ($81) MESSAGE: An invalid connection ID was specified.
CAUSE: The requested Connection ID does not exist.
ACTION: Make the appropriate changes and reissue the request.
130 ($82) MESSAGE: Link did not understand the specified address family.
CAUSE: The Driver detected an error in the address family in the
request message.
ACTION: Fix the configuration file and then try again.
131 ($83) MESSAGE: Link found an error within the specified address family.
CAUSE: The Driver detected an error in the address family in the
request message.
ACTION: Fix the configuration file and they try again.
132 ($84) MESSAGE: An invalid or redundant protocol SAP address was
specified.
CAUSE: For the Rendezvous Request, the LSAP value is the NULL or
Global SAP. For the connect request, this error indicates that this SAP
already has a link to the specified RSAP and destination address
combination, or the remote SAP specified was the null SAP, global SAP,
or a group SAP.
ACTION: Use an acceptable SAP and Destination Address.
133 ($85) MESSAGE: The specified local Protocol SAP was already opened.
CAUSE: For the Rendezvous Request, this error indicates that the LSAP
has already opened.
ACTION: Use an acceptable SAP value.