NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 1 17
CIERR Error Messages
5025 MESSAGE: TOO MANY TRACE OPTIONS (MAXIMUM OF 10).
CAUSE: There were more than 10 TRACE options specified in a DSLINE
command.
ACTION: Consolidate the TRACE options into less than 10, or break the
DSLINE command into two or more DSLINE commands, each with less
than 10 TRACE options.
5026 MESSAGE: DS/3000 DSLINE OPTION IS IGNORED FOR NS NODE.
CAUSE: A DSLINE command for an NS node environment specified a
DS/3000 option that is not supported for the NS node. The unsupported
DS options are LOCID, REMID, PHNUM, LINEBUF, EXCLUSIVE,
SELECT, FROMADR, FROMADDR, TOADR, TOADDR, QUEUE, and
NOQUEUE.
ACTION: None.
5027 MESSAGE: INVALID DSLINE OPTION; EXPECTED QUIET, PROMPT,
LOGON, COMP, NOCOMP, CLOSE, RESET, SHOW, OR TRACE.
CAUSE: An unknown option keyword was found in a DSLINE.
ACTION: Correct or delete the option and reissue the command.
5028 MESSAGE: INTERNAL DS ERROR — COULD NOT ADD VTREQ PORT.
CAUSE: The port used for communication between the CI and the
Virtual Terminal server could not be added to the MPE port dictionary.
ACTION: See Appendix A , “Submitting a CR.”
5029 MESSAGE: INTERNAL DS ERROR — COULD NOT SEND CHANGE
REQUEST.
CAUSE: The VT change request could not be sent to the DSDAD process
port.
ACTION: See Appendix A , “Submitting a CR.”
5030 MESSAGE: INTERNAL DS ERROR — COULD NOT SEND START VT
MSG.
CAUSE: The Start VT port message could not be sent to the Virtual
Terminal server process.
ACTION: See Appendix A , “Submitting a CR.”
5031 MESSAGE: INTERNAL DS ERROR — COULD NOT CREATE VT REQ
PORT.
CAUSE: A port to be used for communication between the CI and the
Virtual Terminal server process could not be created.
ACTION: See Appendix A , “Submitting a CR.”