NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 16 179
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
61 ($3D) MESSAGE: Adapter card produced an illegal interrupt.
CAUSE: The link driver has received an interrupt from the card during
normal operation, but the driver should have specifically disabled that
interrupt at startup.
ACTION: The driver will attempt to perform a dump of all host context
data structures and adapter card memory, then reset itself and
continue. Save the resulting NETDMP##.PUB.SYS file for possible
analysis by Hewlett-Packard. But first, replace the adapter card and
see if this corrects the problem. If not, see Appendix A , “Submitting a
CR.”
62 ($3E) MESSAGE: No adapter card found on specified HP-PB bus.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator did not find an HP-PB bus at the hardware
path specified in NMCONFIG.
ACTION: Verify the path in NMCONFIG is correct and complete, and
matches the path where a supported 100VG-AnyLAN or HP-PB
100Base-T adapter card is installed in your computer backplane. If the
path passes through bus converters, verify the SYSGEN configuration
has entries for the higher-level bus converters leading to that path. If
necessary, change NMCONFIG or contact your Hewlett-Packard
Representative for assistance in determining paths or correcting bus
hardware problems.
63 ($3F) MESSAGE: Adapter card found does not match software
configuration.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator found a supported adapter card at the path
specified in NMCONFIG, but it was not the right type of card for the
link being started.
ACTION: Correct the network configuration or plug in the correct type of
adapter card, and retry the operation.
64 ($40) MESSAGE: Memory test failed: memory data miscompare.
CAUSE: Upon reaching the end of a diagnostic test of adapter card
memory or LAN controller chip memory, the driver had accumulated at
least one data pattern mismatch.
ACTION: One or more data patterns written by the driver did not match
the data read back from those same memory locations. Depending on
which test was being performed, either the adapter card or LAN
controller chip is faulty. Replace the adapter card.
75 ($4B) MESSAGE: Cannot install interrupt handler.
CAUSE: During initial driver startup, the driver was unable to add its
ISR into the MPE I/O system, as an interrupt handler routine for any
adapter card interrupts on that EIR bit.