NS3000/iX Error Messages Reference Manual (36923-90043)

20 Chapter1
CIERR Error Messages
5044 MESSAGE: ALL DSLINE OPTIONS BUT RESET ARE IGNORED.
CAUSE: Other options besides RESET were specified in a DSLINE
command.
ACTION: None (the selected environment is closed).
5045 MESSAGE: DSLINE OPTION OVERRIDES PREVIOUS DSLINE
OPTION.
CAUSE: More than one DSLINE option was included in a REMOTE HELLO
command. The last DSLINE option is used.
ACTION: None (the REMOTE HELLO will be executed).
5046 MESSAGE: DSLINE OPTION IGNORED.
CAUSE: Both the envid and DSLINE=envid options were specified in a
REMOTE HELLO command. The envid is used to select the environment.
ACTION: None (the REMOTE HELLO will be executed).
5047 MESSAGE: GENERIC ENVIRONMENT ID NOT ALLOWED HERE.
CAUSE: A generic environment ID (with the wild card characters @, #,
and/or ?) was used in the envid or DSLINE=envid option of a REMOTE
command.
ACTION: Correct the syntax and reissue the command. If you want to
execute a REMOTE command for a set of environments, you must issue a
separate REMOTE for each environment.
5048 MESSAGE: NO DEFAULT ENVIRONMENT FROM PREVIOUS :DSLINE
OR :REMOTE.
CAUSE: A REMOTE or DSLINE command was issued without an
environment ID or environment number, and there is no default
environment set by a previous command.
ACTION: Insert an environment ID or number into the syntax and
reissue the command.
5049 MESSAGE: INVALID NSCONTROL OPTION: EXPECTED START, STOP,
ABORT, SERVER, LOG, DEBUG, STATUS, AUTOLOGON, OR
VERSION.
CAUSE: An unknown option keyword was found in an NSCONTROL
command.
ACTION: Correct or delete the keyword and reissue the command.
5050 MESSAGE: TOO MANY NSCONTROL OPTIONS.
CAUSE: The information in the NSCONTROL command is too large to be
sent to the DSDAD process for processing.
ACTION: Consolidate options in the command, or break the command
into two or more NSCONTROL commands.