NS3000/iX Error Messages Reference Manual (36923-90043)

22 Chapter1
CIERR Error Messages
5060 MESSAGE: INTERNAL DS ERROR — COULD NOT SEND CONTROL
MESSAGE.
CAUSE: The port message with the NSCONTROL information could not be
sent from the CI to the DSDAD process.
ACTION: See Appendix A , “Submitting a CR.”
5061 MESSAGE: DSDAD.NET.SYS DOES NOT EXIST.
CAUSE: The DSDAD.NET.SYS program file is missing.
ACTION: Restore the DSDAD.NET.SYS file from the NS product tape.
5062 MESSAGE: INVALID CONTROL OPTION.
CAUSE: This CI error is returned for errors detected during the
processing of an NSCONTROL command. One or more DS errors will
accompany this CI error to more fully describe the error or errors.
ACTION: Correct the error, based on the DS error(s), and reissue the
command.
5063 MESSAGE: INVALID SERVER PIN.
CAUSE: The server process ID number (PIN) in a DEBUG option in an
NSCONTROL command is not numeric.
ACTION: Correct the PIN and reissue the command.
5064 MESSAGE: PROMPT MUST BE 8 CHARACTERS OR LESS.
CAUSE: The prompt string in a DSLINE PROMPT option is longer than
the maximum of 8 characters.
ACTION: Shorten the prompt string and reissue the command.
5065 MESSAGE: LOGON MUST BE 54 CHARACTERS OR LESS.
CAUSE: The logon string in a DSLINE LOGON option is longer than the
maximum of 54 characters.
ACTION: Shorten the logon string and reissue the command.
5067 MESSAGE: INTERNAL ERROR — DSLINE JCW NOT FOUND.
CAUSE: The DSLINE Job Control Word, set to the DSLINE number by the
DS software, could not be found.
ACTION: See Appendix A , “Submitting a CR.”
5072 MESSAGE: ABORT DOES NOT ACCEPT ANY PARAMETERS.
CAUSE: Parameters were specified for an NSCONTROL ABORT option.
ACTION: Delete the parameters and reissue the command.
5073 MESSAGE: ABORT DOES NOT ACCEPT ANY PARAMETERS.
CAUSE: Parameters were specified for an :NSCONTROL ABORT option.