NS3000/iX Error Messages Reference Manual (36923-90043)

228 Chapter16
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
4030 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received a release-memory reply message it was not
expecting (“Cause” = 16-bit encoded value, giving driver input event
code and current state: HP use only).
ACTION: The driver may already have changed state because of a
shutdown or another problem, in which case this message can be
ignored. Otherwise, the I/O system may be confused. The driver will
drop this message without further action. If the problem occurs
repeatedly, see Appendix A , “Submitting a CR.”
4060 CLAS0001 MESSAGE: A driver request failed.
CAUSE: While attempting to forward a protocol rendezvous (bind)
message to its ISR, the driver encountered an error (“Cause” = 32-bit
status returned by the call to vg_dvr_copy_send_to_isr). Probably no
comm frame was available.
ACTION: This informational error should be preceded by another error
giving a more specific reason for the failure; check log data and look up
that error also, for more actions to take. Most likely the previous error
was fatal and the driver is about to “die”, then will either attempt an
auto-reset or else require a manual shutdown and restart. The driver
dropped this request message without further action, likely resulting in
timeouts and failure of the network and/or protocol to successfully start
up.
4090 CLAS0001 MESSAGE: Driver encountered a software problem.
CAUSE: Before attempting to forward a protocol rendezvous (bind)
request to its ISR, the driver discovered the ISR was already in a “dead”
state and unable to process requests (“Cause” = 32-bit status stating
the driver is “dying”).
ACTION: If the operator already knows the driver is in the process of
being closed, this error can be ignored. The driver attempted to send an
error reply for the rendezvous request. The ISR may also be “dead” as a
result of a serious previous error. A diagnostic reset action may clear
this condition.
4120 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received a request to reset itself too early in the
driver’s life cycle before it had ever brought up the adapter card, or at a
point late in shutdown when recovery is no longer needed
(“Cause” = 16-bit encoded value, giving driver input event code and
current state: HP use only).
ACTION: This error is informational only. If the reset request was
manually sent by a user, such as via the VGPBA diagnostic tool, an
error reply will be returned; resets are not allowed (or needed) when
the driver is in the state it is currently in. If the reset was automatically
generated by the driver in response to some serious error it detected,