NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 1 23
CIERR Error Messages
ACTION: Delete the parameters and reissue the command.
5074 MESSAGE: EXPECTED ONE OF USERS, SERVICES, SERVERS, OR
ALL.
CAUSE: The parameter for a SHOW option in an NSCONTROL command
was not one of the defined choices.
ACTION: Correct the SHOW command and reissue the parameters.
5075 MESSAGE: EXPECTED MAXIMUM NUMBER OF SERVERS (=> 0 and
>32767).
CAUSE: The third parameter of a SERVER option in an NSCONTROL
command was not a maximum number of servers, a positive integer.
ACTION: Correct the SERVER option and reissue the command.
5076 MESSAGE: WILD CARD CHARACTERS NOT ALLOWED IN NODE
NAME.
CAUSE:A wild card character (@, #, or ?) was used in a node name. Node
names cannot be generic.
ACTION: Correct the node name and reissue the command.
5077 MESSAGE: NETWORK SERVICE SOFTWARE VERSIONS DO NOT
MATCH.
CAUSE: The version or update, or fix levels of the Network Service
software modules are not compatible. NS cannot be initiated if its
software is incompatible.
ACTION: List the versions for the NS software modules, using
NSCONTROL VERSION=MOD or RUN NMAINT.PUB.SYS. Identify the
incompatible software modules, and replace with the assistance of your
SE.
5078 MESSAGE: PM CAPABILITY NEEDED TO USE DEBUG OPTION.
CAUSE: An NSCONTROL DEBUG or NSCONTROL SERVER=,,,DEBUG
command was executed, but the user does not have PRIVILEGED
MODE (PM) capability. These commands cause a privileged breakpoint
to be activated.
ACTION: Execute the command from a user with PM capability.
5079 MESSAGE: SYSTEM CONSOLE NEEDED TO USE DEBUG OPTION.
CAUSE: An NSCONTROL DEBUG or NSCONTROL SERVER=,,,DEBUG
command was executed from a terminal other than the system console.
These commands cause a breakpoint to appear at the system console.
ACTION: Execute the command from the system console.
5080 MESSAGE: EXPECTED GENERIC ENVIRONMENT ID.
CAUSE: In a DSLINE RESET, the environment ID was not generic.