NS3000/iX Error Messages Reference Manual (36923-90043)

276 Chapter16
100VG-AnyLAN and HP-PB 100Base-T Error Messages
SDI Driver Specific Status Values
9800 (None) MESSAGE: (None)
CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read the
network status register, but detected a powerfail instead. A power
failure state was then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: If a power failure has actually occurred, this error can be
ignored; the driver should recover automatically. If the problem
happens every time, see Appendix A , “Submitting a CR.”
9830 (None) MESSAGE:
(None)
CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read the
PHY status register on the PHY chip, but detected an error. A hardware
failure state was then signaled. Probably a powerfail occurred.
If a power failure has actually occurred, this error can be ignored; the
driver should recover automatically. Otherwise, the MII bus may have
failed; replace the adapter card. If the same problem persists, see
Appendix A , “Submitting a CR.”
9860 (None) MESSAGE:
(None)
CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read a
statistics register, but detected a powerfail instead. A power failure
state was then signaled.
This code would only appear in the formatted PHY chip trace from a
100VG-AnyLAN link connect failure. It would not appear in a log event.
Seeing this error implies you are already using link tracing to try to
debug a problem, or are analyzing driver context data directly.
ACTION: If a power failure has actually occurred, this error can be
ignored; the driver should recover automatically. If the problem
happens every time, see Appendix A , “Submitting a CR.”
9890 (None) MESSAGE:
(None)
CAUSE: 100VG-AnyLAN link training failed because, after the LAN
Controller chip reported a status interrupt, the driver tried to read the
generic register on the PHY chip, but detected an error. A hardware
failure state was then signaled. Probably a powerfail occurred.
If a power failure has actually occurred, this error can be ignored; the
driver should recover automatically. Otherwise, the MII bus may have
failed; replace the adapter card. If the same problem persists, see
Appendix A , “Submitting a CR.”