NS3000/iX Error Messages Reference Manual (36923-90043)

280 Chapter17
PCI 100Base-T Error Messages
SDI Generic Status Values
SDI Generic Status Values
0 ($00) MESSAGE: No error, info only.
CAUSE: None
ACTION: None
1 ($01) MESSAGE: The driver detected an exception in hardware operation.
CAUSE: The driver detects an exception in hardware operation. At this
state, the only type of requests that would be processed are the
diagnostic requests or Module Deconfigurator Call.
ACTION: Stop the normal operation and execute the diagnostic
software.
2 ($02) MESSAGE: Adapter card firmware reported an error.
CAUSE: The firmware reports an error, at this state, the driver would
stop the normal operation and process diagnostic requests or Module
Deconfigurator Call.
ACTION: Stop the normal operation and execute error recovery
software.
3 ($03) MESSAGE: A power failure occurred.
CAUSE: A power failure occurred. The driver failed to process the
powerfail recovery.
ACTION: According to the subsystem.
4 ($04) MESSAGE: Error in interface with Operating System.
CAUSE: Errors in interfacing with the operating system (example, ports,
memory, procedures, I/O services etc.).
ACTION: According to the situation.
5 ($04) MESSAGE: Error in interface with Buffer Manager.
CAUSE: An error was detected in interfacing with Buffer Manager
(example, Nil buffer pointer in read/write, nil buffer pool ID, etc.).
ACTION: According to the situation.
6 ($06) MESSAGE: General error in operation of link driver software.
CAUSE: This is a “catch all” error for the ultimate non-specific driver
error.
ACTION: According to the implementation.