NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 17 281
PCI 100Base-T Error Messages
SDI Generic Status Values
7 ($07) MESSAGE: Inadequate resources available to satisfy a request.
CAUSE: There are inadequate SAP control block, buffers, or link
stations available to satisfy the request.
ACTION: According to the situation, close some SAPs/stations or wait.
8 ($08) MESSAGE: An adapter card is not responding.
CAUSE: The driver detects an exception in hardware operation. At this
state, the only type of requests that would be processed are the
diagnostic requests or Module Deconfigurator Call.
ACTION: Stop the normal operation and execute the diagnostic
software.
9 ($09) MESSAGE: The require context area was not valid.
CAUSE: A failure occurred when attempting to dereference an internal
link data structure.
ACTION: According to the subsystem; the link may not be able to start
properly.
10 ($0A) MESSAGE: A data transmission or reception problem occurred.
CAUSE: The driver encountered an error or unexpected condition when
attempting to process transmit or receive data over the link.
ACTION: According to the subsystem.
29 ($41) MESSAGE: Could not establish requested connection, but can retry.
CAUSE: The Connect Request could not establish a requested
connection, however, it is a recoverable situation.
ACTION: Start a timer and try again when timer popped.
42 ($2A) MESSAGE: Could not establish requested connection, cannot retry.
CAUSE: The Connect Request could not establish a requested
connection and it is not a recoverable situation.
ACTION: Determine the cause for the failure and try again when
resolved.
43 ($2B) MESSAGE: Could not establish requested connection, no remote
response.
CAUSE: The Connect Request could not establish a requested
connection.
ACTION: Check the configuration and make sure the remote system is
up and running.
44 ($2C) MESSAGE: Remote connections are still active.
CAUSE: For the Separate Request, there are connections still active on
the LSAP, the driver did not close the LSAP or disconnect the