NS3000/iX Error Messages Reference Manual (36923-90043)

290 Chapter17
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
26 ($1A) MESSAGE: Internal error while initiating a dump. Dump failed.
CAUSE: During processing of some other fatal driver error, the driver
attempted a driver dump, but encountered an error.
ACTION: This error is mainly informational, since the driver did not
dump, but may be indicative of other, possibly-related problems. The
driver will still attempt to auto-reset itself, up to a total of 12 times or
more.
27 ($1B) MESSAGE: Late dump-done message received. Dump took too long.
CAUSE: The driver received a driver-dump completion message when it
was not working on a dump.
ACTION: This error is informational only. Probably the Network Dump
Process was delayed by other system processing, such that it exceeded
the time limit set by the driver. The resulting dump file may or may not
be incomplete. A more serious driver problem has already occurred,
after which the driver will now attempt to auto-reset and continue. If
you are trying to reproduce a specific problem but this error occurs
every time, reduce the CPU or disk activity load before the next
attempt. If load is not the problem, see Appendix A , “Submitting a CR.”
28 ($1C) MESSAGE: A driver dump is starting.
CAUSE: A user is forcing a driver dump to occur, typically via the
VGPBA diagnostic tool program.
ACTION: This error is informational only. The dump is probably being
forced because the system operator suspects a link driver problem.
Forward the resulting NETDMP##.PUB.SYS file to Hewlett-Packard for
analysis if necessary, and see Appendix A , “Submitting a CR.”
29 ($1D) MESSAGE: A driver dump is starting.
CAUSE: The driver has requested a dump, and the dump process is
logging that the dump is about to occur. This is logged during setup of
the dump file.
ACTION: This error is informational only; however, the dump may be
occurring because the link driver detected other errors. Look for any
other errors logged by the link driver and note them. Forward the
resulting NETDMP##.PUB.SYS file to Hewlett-Packard for analysis if
necessary, and see Appendix A , “Submitting a CR.”
31 ($1F) MESSAGE: A driver dump was suppressed. Too many dumps already.
CAUSE: During processing of a fatal driver error, the driver attempted a
driver dump, but determined it had already dumped too many times
since it was initially started.
ACTION: By design, the driver attempts to auto-reset itself after any
driver dump. But after 3 dumps, to avoid uncontrollably filling disk
space with driver dumps, additional dumps are automatically