NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 17 311
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
243 ($F3) MESSAGE: Unknown data version.
CAUSE: The trace or log formatter attempted to decode a record header
to obtain general information such as link type and link name, but on
inspection found that the version of that data was not supported by his
formatter, thus no other fields could be decoded.
ACTION: The formatter will attempt to print this record in the raw
form. You may be trying to format a trace or log file taken on a different
system that has newer software than the system you are formatting on.
Format the file on the system you took the trace or log on, or contact
your Hewlett-Packard Representative to check if patches are already
available to update the software on your current system.
244 ($F4) MESSAGE: Error encountered while decoding an entry.
CAUSE: The trace or log formatter encountered an entry having an
unrecognized entry tag value. The formatter cannot decode entries of
this type.
ACTION: The formatter will attempt to print this record in raw form.
You may be trying to format a trace or log file taken on a different
system that has newer software than the system you are formatting on.
Format the file on the system you took the trace or log on, or contact
your Hewlett-Packard Representative to check if patches are already
available to correct this problem.
245 ($F5) MESSAGE: Incomplete data was encountered.
CAUSE: The trace or log formatter attempted to decode an entry, but on
inspection found that the entry did not contain at least the minimum
length of data required for this version of the data.
ACTION: The trace or log file may be corrupted, or you may be trying to
format a trace or log file taken on a different system that has newer
software than the system you are formatting on. The formatter will
attempt to print this entry in raw form. Format the file on the system
you took the trace or log on, or contact your Hewlett-Packard
Representative to check if patches are already available to correct this
problem.