NS3000/iX Error Messages Reference Manual (36923-90043)

316 Chapter17
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify the path in NMCONFIG is correct and complete, and matches
the path where a supported 100Base-T adapter card is installed in your
computer backplane. If the path passes through bus converters, verify
the SYSGEN configuration has entries for the higher-level bus
converters leading to that path. A diagram of the backplane slot paths,
often found in the rear of your system near the backplane, may help
you. If necessary, change NMCONFIG or contact your Hewlett-Packard
Representative for assistance in determining paths or correcting bus
hardware problems.
1400 CLAS0001 MESSAGE: Cannot open configuration file.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator encountered an error while trying to open the
configuration file (“Cause” = 32-bit status from the call to nmconfopen).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Verify an NMCONFIG.PUB.SYS file exists. If so, try to verify its format
matches rest of the operating system. If the system was updated, you
may need to run NMMGRVER.PUB.SYS to convert the file to a newer
format. If the system was backdated, you may need to restore an older
copy of NMCONFIG from a backup tape.
Perform a :LISTF,3 command and make sure the file is not protected
by a lockword, and that the user starting the link has the necessary
access rights to open the file.
Perform a :DSTAT ALL command and make sure the disk drive the file
resides on is present and mounted. Make sure the file resides on Ldev 1.
If not, use Fcopy and a file equation with a “;DEV=1” option to force a
copy of the file onto Ldev 1.
Perform a :SHOWPROC 1;TREE;SYSTEM command and verify an
NMFILE process exists. If not, shut down and restart the system, and
retry the operation. If the problem persists, contact your
Hewlett-Packard Representative for assistance with NMCONFIG file
open problems.
1420 CLAS0001 MESSAGE: Cannot read from configuration file.
CAUSE: During a link-open operation by an upper level subsystem, the
link module configurator was able to open the configuration file, but
encountered an error while trying to data for the link being started
(“Cause” = 32-bit status from the call to nmconfopen).
ACTION: The module configurator cleaned up and returned an error to
the subsystem.
Using NMMGR, verify the path LINK.linkname exists in the