NS3000/iX Error Messages Reference Manual (36923-90043)

34 Chapter2
DSERR Error Messages
627 MESSAGE: CANNOT OPEN TRACE FILE filename.
CAUSE: A DSLINE TRACE=ON was issued, but the indicated trace file
cannot be opened.
ACTION: Check the parameters for the TRACE option, correct if in error,
and reissue the command.
628 MESSAGE: CANNOT CLOSE TRACE FILE filename.
CAUSE: A DSLINE TRACE=OFF was issued, but the indicated trace file
cannot be closed.
ACTION: Check the parameters for the TRACE option, correct if in error,
and reissue the command.
629 MESSAGE: CANNOT OBTAIN DATA SEGMENT FOR ENVIRONMENT
TABLE.
CAUSE: An extra data segment was not available for the session
environment table, because of a lack of memory or DST entries. No
environments can be defined.
ACTION: Wait and reissue the command later, when memory or DST
entries may become available. If this error occurs frequently, there may
be insufficient DST entries or memory. The system manager may have
to increase the DSTs or memory.
630 MESSAGE: CANNOT CHANGE NODE NAME FROM nodename WHILE
ACTIVE SERVICES.
CAUSE: A DSLINE envid = nodename was executed for an environment
for which one or more services have been established on a remote node
other than nodename. The environment of this node cannot be changed
until the services are finished.
ACTION: Wait for the services to terminate, or terminate the services.
The DSLINE SHOW command can be used to determine the active
services for the environment.
631 MESSAGE: INVALID ENVIRONMENT ID OR NODE NAME LENGTH.
CAUSE: A fully qualified environment or node name in a command was
longer than the allowed maximum of 50 characters.
ACTION: Shorten the name and reissue the command.
632 MESSAGE: ID OR NODE IN name DOES NOT BEGIN WITH AN ALPHA.
CAUSE: The first part of a (fully qualified) environment ID or node name
does not begin with an alphabetic character.
ACTION: Correct the name and reissue the command.
633 MESSAGE: ID OR NODE IN name IS GREATER THAN 16
CHARACTERS.
CAUSE: The first part of a (fully qualified) environment ID or node name