NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 17 341
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
4740 CLAS0001 MESSAGE: Cannot send a port message.
CAUSE: The driver was unable to successfully unbind from its lower
manager. Probably an underlying call to send_msg failed.
ACTION: No action is required; this is an informational message. This
error may be preceded by other errors in the log file giving a more
specific reason for the failure. Check the log data and look up additional
errors for more possible actions. If the problem persists, halt the system
and generate a dump; see Appendix A , “Submitting a CR.”
4770 CLAS0001 MESSAGE: Cannot send a port message.
CAUSE: During shutdown, the driver was unable to successfully unbind
from its lower manager. Probably an underlying call to send_msg failed.
ACTION: No action is required; this is an informational message. There
might be a system problem that precipitated the shutdown which is
preventing messages from being sent successfully. If the problem
persists, collect all the relevant data from the log file and check those
errors for additional actions. If the problem persists halt the system as
soon as possible after the problem occurs and generate a dump; see
Appendix A , “Submitting a CR.”
4800 CLAS0001 MESSAGE: Late dump-done message received. Dump took too long.
CAUSE: The driver received a driver-dump completion message when it
was not working on a dump (“Cause” = 32-bit status saying there was a
bad message for the current state).
ACTION: This error is informational only. Probably the Network Dump
Process was delayed by other system processing, such that it exceeded
the time limit set by the driver. The resulting dump file may or may not
be incomplete. A more serious driver problem has already occurred,
after which the driver will now attempt to auto-reset and continue. If
you are trying to reproduce a specific problem but this error occurs
every time, reduce the CPU or disk activity load before the next
attempt.
If load is not the problem, see Appendix A , “Submitting a CR.”
4830 CLAS0001 MESSAGE: Internal error while initiating a dump. Dump failed.
CAUSE: The driver’s dump timer popped while performing a dump
operation (“Cause” = 32-bit status indicating a timeout has occurred).
Probably a heavy CPU or disk activity load caused the Network Dump
Process to take longer than the time allowed by the driver.
ACTION: This error is informational only. The resulting dump file may
or may not be incomplete. A more serious driver problem has already
occurred, and by the time this error is logged, the driver is already
attempting to auto- reset and continue. If you are trying to reproduce a
specific problem but this error occurs every time, reduce the CPU or
disk activity load before the next attempt.