NS3000/iX Error Messages Reference Manual (36923-90043)

376 Chapter17
PCI 100Base-T Error Messages
SDI Driver Specific Status Values
9840 CLAS0001 MESSAGE: Driver encountered a software problem.
CAUSE: While processing a receive completion interrupt from the
adapter card, the ISR encountered an error (“Cause” = 32-bit status
from Pbt_isr_receive_frame).
ACTION: This error is informational; if possible the driver will log the
error and continue. There may be additional error information and
messages logged which provides more information about the error. The
driver may perform an auto-reset, depending on the severity of the
error.
If the problem persists, try forcing a dump of the driver via the VGPBA
tool, or generating a link trace. Send any dump or trace files
(NETDMP##.PUB.SYS, NMTC###.PUB.SYS) to Hewlett-Packard for
analysis; see Appendix A , “Submitting a CR.”
9870 CLAS0001 MESSAGE: Adapter card reported a fatal bus error.
CAUSE: The ISR processed an interrupt from the adapter card and
detected the fatal bus error bit was set in the card’s status register.
ACTION: This is a fatal hardware error. The adapter card or system I/O
hardware may have failed. Contact your Hewlett-Packard
representative for assistance.