NS3000/iX Error Messages Reference Manual (36923-90043)

40 Chapter3
NS/NFTERR and NS/NFTWARN Messages
20 MESSAGE: TARGET RECORD SIZE IS INVALID.
CAUSE: Requested RSIZE is too large.
ACTION: Specify a smaller record size.
21 MESSAGE: TARGET FILE SIZE IS INVALID.
CAUSE: Requested FSIZE is too large.
ACTION: Specify a smaller record size.
22 MESSAGE: DUPLICATE TARGET FILE.
CAUSE: The target file exists and neither REPLACE nor OVERWRITE was
specified.
ACTION: Verify that the target file name is correct, and specify REPLACE
or OVERWRITE.
23 MESSAGE: NEED PASSWORD TO ACCESS SOURCE FILE.
CAUSE: Source file could not be accessed without proper password.
ACTION: Specify the password and the source-file name and try again.
24 MESSAGE: NEED PASSWORD TO ACCESS TARGET FILE.
CAUSE: Target file could not be accessed without proper password.
ACTION: Specify the password and the target-file name and try again.
25 MESSAGE: OUT OF DISK SPACE.
CAUSE: The target computer has run out of disk space. The target file
will not fit.
ACTION: Purge unused files on the target computer and try again.
26 MESSAGE: CONNECTION TO SOURCE NODE HAS GONE DOWN.
CAUSE: An error was detected on the connection to the computer where
the source files reside. If the file-producer program is still active on the
source computer, it will attempt to carry out the remainder of the
user-file copy command (perhaps causing several file transfers to occur
if wildcards were given). If the file producer is no longer active, the
remaining files were not transferred.
ACTION: Determine which, if any, of the files were not transferred.
Transfer these files by specifying the proper command and trying
again.
27 MESSAGE: CONNECTION TO TARGET NODE HAS GONE DOWN.
CAUSE: An error was detected on the connection to the computer where
the target files are to be created. If this error occurs while the file
producer is in the middle of copying several files, the current file may
not have been copied successfully and an attempt will not be made to
copy the remainder of the files.