NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 18 415
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
1860 CLAS0001 MESSAGE: Subsystem is closing link.
CAUSE: An upper level subsystem has called the link module
deconfigurator, which has successfully located the link, and will now
proceed to close it.
ACTION: None. This is an informational event only. A similar event was
logged when the link was opened.
1880 CLAS0001 MESSAGE: Module Configurator cannot access its context area.
CAUSE: During a link-close operation by an upper level subsystem, the
link module deconfigurator checked its context memory area for
validity, but did not find the expected data (“Cause” = 32-bit status
saying the context was not accessed).
ACTION: The module deconfigurator’s context memory area is being
overwritten, or is not working properly. The deconfigurator did not
perform the close. If this happens every time, wait until the next time
the link is to be closed; instead of closing the link, halt the system and
take a memory dump, and see Appendix A , “Submitting a CR.”
1900 CLAS0001 MESSAGE: Cannot delete from link table.
CAUSE: During the final link-close operation by an upper level
subsystem, the link module deconfigurator attempted to delete the link
from the link table, but encountered an error (“Cause” = 32-bit status
from the call to lsslktbldelete).
ACTION: The module deconfigurator reported an error, but attempted to
continue with the close. Network management services may have been
shut down. Otherwise, if this happens every time, see Appendix A ,
“Submitting a CR.”
1920 CLAS0001 MESSAGE: Cannot delete a buffer pool.
CAUSE: During a link-close operation by an upper level subsystem, the
link module deconfigurator encountered an error while trying to delete
a control buffer pool (“Cause” = 32-bit status from the call to
bmgr_delete_pool).
ACTION: This is an informational warning that some system memory
resources may have been lost. Probably not all buffers were freed before
the pool was deleted. The module deconfigurator reported an error, but
attempted to continue with the close. If this happens every time, see
Appendix A , “Submitting a CR.”
1940 CLAS0001 MESSAGE: Cannot release a system plabel.
CAUSE: During the final link-close operation by an upper level
subsystem, the link module deconfigurator encountered an error while
trying to release the link’s write initiator procedure (“Cause” = 32-bit
status from the call to hprelsysplabel).
ACTION: This is an informational warning that some system memory