NS3000/iX Error Messages Reference Manual (36923-90043)

428 Chapter18
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
ACTION: No action is required; this error is informational only. An error
reply was sent in response to the request. Trace was not stopped by this
request this time, but it remains off.
3850 CLAS0001 MESSAGE: Cannot initiate a dump. Already dumping.
CAUSE: A user attempted to force a driver dump while a previous driver
dump was still occurring (“Cause” = 32-bit status saying a driver dump
is starting).
ACTION: A dump of your problem is already being produced. Wait a
minute or two for the dump to finish. Forward the resulting
NETDMP##.PUB.SYS to Hewlett-Packard for analysis if necessary, and
see Appendix A , “Submitting a CR.”
3880 CLAS0001 MESSAGE: A driver dump is starting.
CAUSE: A user is forcing a driver dump to occur, typically via CI
(“Cause” = 32-bit status saying the driver dump was forced).
ACTION: This error is informational only. The dump is probably being
forced because the system operator suspects a link driver problem.
Forward the resulting NETDMP##.PUB.SYS file to Hewlett-Packard for
analysis if necessary, and see Appendix A , “Submitting a CR.”
3910 CLAS0001 MESSAGE: Cannot get ADA memory object.
CAUSE: During initial startup, the driver attempted to obtain a memory
object via the I/O system, but received a bad status in the reply for that
request (“Cause” = 32-bit status from the reply message).
ACTION: The link did not start, and the driver attempted to send back
an error reply in response the configuration request from the module
configurator. Probably the amount of frozen memory on the system is
very high; if you have the GLANCE tool you can try to check memory
usage. Try retrying the operation again later, or first terminate some
applications and then retry.
4000 CLAS0001 MESSAGE: Cannot release ADA memory object.
CAUSE: During shutdown, the driver requested the I/O system to
release a memory object, but received an error reply in response
(“Cause” = 32-bit status from the mem_reply message).
ACTION: This error should not occur. The driver may be confused, or
there is a system problem. However, the driver will ignore the error and
attempt to continue with the shutdown. If this problem happens
frequently when the driver is shutting down, see Appendix A ,
“Submitting a CR.”
4000 CLAS0001 MESSAGE: Link tracing is already enabled.
CAUSE: The driver received a request to turn link tracing off when it
was already off. Typically this condition is caught at the C.I. level,
however in this case trace may be under the control of a different