NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 18 429
PCI LAPBMUX Link Error Messages
SDI Driver Specific Status Values
mechanism.
ACTION: No action is required; this error is informational only. An error
reply was sent in response to the request. Trace was not stopped by this
request this time, but it remains off.
4040 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received a trace enable request, at a time the driver
was not able to process these requests. (“Cause” = 16-bit encoded value,
giving driver input event code and current state: Hewlett-Packard use
only).
ACTION: Try this operation later. If the problem still persists. If the
driver still does not become usable after this, use Control-B at the
console to halt the system, take a memory dump, and reboot, see
Appendix A , “Submitting a CR.”
4270 CLAS0001 MESSAGE: Bad message for current state.
CAUSE: The driver received an unconfigure request message before it
received its first configure request (“Cause” = 16-bit encoded value,
giving driver input event code and current state: HP use only).
ACTION: This error is informational only. The driver attempted to
return an error reply tothe sending subsystem. If this problem happens
frequently, try to determine what actions lead to the problem, then see
Appendix A , “Submitting a CR.”
4970 CLAS0001 MESSAGE: Powerfail detected.
CAUSE: A power failure appears to have occurred during a hard reset of
the adapter card during startup (“Cause” is not used here).
ACTION: This is an informational error only. The driver should have
then attempted to recover from the powerfail. If you suspect a powerfail
has not occurred, and the same problem occurs on every restart, the
adapter card or system HP-PB hardware may have failed. Replace the
adapter card. Then, if the problem still persists, contact your
Hewlett-Packard Service Representative for help in diagnosing your
system hardware.
5000 CLAS0001 MESSAGE: Level-2 connection not happened within time allowed.
CAUSE: During a WAN link connect attempt, the driver requested a
level-2 connection from the remote host, but no connection happened
within the connect time allowed.
ACTION: This error is informational only. The driver will retry the
connect. If the problem happens every time, first check that the cable is
good, If the cable is good, then check the NMMGR configuration like
clock setting, interface type, Local mode (DTE or DCE) etc.