NS3000/iX Error Messages Reference Manual (36923-90043)

438 Chapter20
LAP-B Link Error Messages
LAP-B Link Startup Error Messages
LAP-B Link Startup Error Messages
The following message will automatically be displayed on the operator’s
console when a network transport tries to startup the WAN driver:
WAN MODULE CONFIG (linkname) Version: A0001037
This section describes error messages that might occur when you are
starting a LAP-B link. They are displayed on the HP e3000 operator’s
console in the following format:
WAN MODULE CONFIG (linkname) Message text
WAN MODULE CONFIG (linkname) Error ErrorNum,
Status = Status, Path: PhysPath
1 MESSAGE: The link type is not SDLC, LAP-B, or RJE.
CAUSE: The caller of this module did not set the link type to one of
SDLC, LAP-B, or RJE.
ACTION: Please record the error information printed on the console and
contact your Hewlett-Packard representative.
2 MESSAGE: Could not open NMCONFIG.PUB.SYS.
CAUSE: Either the NMCONFIG.PUB.SYS file was purged or renamed, or
the file NMCONFIG.PUB.SYS was opened with exclusive access.
ACTION: Restore the file NMCONFIG.PUB.SYS from a backup tape, or
wait for the program or process that has this file opened exclusively to
close it.
3 MESSAGE: Link data not found in NMCONFIG.PUB.SYS.
CAUSE: The link data in the file NMCONFIG.PUB.SYS does not exist.
ACTION: Using the program NMMGR.PUB.SYS, create the link data
associated with the link you are trying to start up.
4 MESSAGE: Could not close NMCONFIG.PUB.SYS.
CAUSE: The file NMCONFIG.PUB.SYS, which contains configuration
information could not be closed. This did not prevent the link from
starting, but it is worth noting because this should not happen. The file
system integrity may be in question.
ACTION: Please record the error information printed on the console and
contact your Hewlett-Packard representative.
5 MESSAGE: Could not open download file.
CAUSE: Either the file PSILAPB0.PUB.SYS was purged or renamed, or
the file was opened for exclusive access.