NS3000/iX Error Messages Reference Manual (36923-90043)

Chapter 20 441
LAP-B Link Error Messages
LAP-B Link Startup Error Messages
20 MESSAGE: Could not create or bind with the driver.
CAUSE: Possible causes for this problem are as follows:
1. (Status = FAxx00D9) The I/O subsystem still has the card
configured and marked active.
2. (Status = E0xx00D5) The Bus converter is not configured.
3. (Status = DAxx00D5) There is no card in the slot for the path
number given.
4. (Status = CDxx00D5) The card is bad for the path number given.
5. (Status = C3xx00D9) The wrong card exists for the path number
given.
ACTION: Possible actions for this problem are as follows:
1. Try shutting down the link first. The system may need to be
restarted. If this does not work then record the error information
printed on the console and contact your Hewlett-Packard
representative.
2. Check the bus converter configuration in SYSGEN. You may need to
configure the bus converter using SYSGEN (Series 950 only).
3. Set the correct physical path number in NMCONFIG.PUB.SYS for this
link or contact your Hewlett-Packard representative to install a PSI
card.
4. Verify that the physical path configured for the link matches with a
good PSI card. Run Sherlock Diagnostics to determine if the PSI
card is good. Contact your Hewlett-Packard representative if you
need to install a good PSI card.
5. Set the correct physical path number in NMCONFIG.PUB.SYS for this
link.
21 MESSAGE: Could not add the link name to the link table.
CAUSE: Possible causes for this problem are as follows:
1. Another the link with the same name has already started.
2. The link table was corrupted.
3. The link table does not exist.
ACTION: Possible actions for this problem are as follows:
1. Try shutting down the link and starting it up again.
2. Please record the error information printed on the console and
contact your Hewlett-Packard representative.
3. The system may need to be restarted.