NS3000/iX Error Messages Reference Manual (36923-90043)

444 Chapter20
LAP-B Link Error Messages
LAP-B Link Driver Error Messages
1004 MESSAGE: PSI fatal error, dinmode.
CAUSE: Possible causes for this problem are as follows:
1. The download file is corrupt.
2. Bad PSI hardware.
ACTION: Possible actions for this problem are as follows:
1. Replace the download file from your latest system update tape.
2. Run the Sherlock diagnostics on the PSI and call your
Hewlett-Packard representative if a failure is detected.
1005 MESSAGE: PSI fatal bus error.
CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update tape,
and run the Sherlock diagnostics on the PSI. Call your
Hewlett-Packard representative if a failure is detected.
1006 MESSAGE: PSI fatal internal error.
CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update tape,
and run the Sherlock diagnostics on the PSI. Call your
Hewlett-Packard representative if a failure is detected.
1007 MESSAGE: Unknown PSI fatal error.
CAUSE: Either the download file is corrupt, or the PSI hardware has
failed.
ACTION: Replace the download file from your latest system update tape
and run the Sherlock diagnostics on the PSI and call your
Hewlett-Packard representative if a failure is detected.
1008 MESSAGE: The PSI received less data from your Hewlett-Packard
system than it expected.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.
1009 MESSAGE: The PSI received more data from your Hewlett-Packard
system than its internal buffers could handle.
CAUSE: Internal error.
ACTION: Write down the error information displayed on the console,
submit an CR, and call your Hewlett-Packard representative.